How margin stops work
A manual typewriter has two margin stops, one for the left and one for the right. They are small blocks that slide along a scale on the carriage. When the carriage reaches a stop, it cannot move any further, which locks the keyboard or blocks the carriage. The right-hand stop usually also triggers the bell, which rings a few characters before the stop to warn you the line is almost full.
Controls differ by model. On some machines you squeeze or lift the stop and slide it. On others, you press a button or set the stop with a key. If you have the manual for your model, follow it (for one example, see the Imperial Good Companion instructions), and treat the steps below as a general guide.
Before you start
- Put a sheet of paper in the machine and line it up against the paper guide. See the parts of a typewriter if you need to find it.
- Find the scale. It is usually printed along the carriage or at the front, and it is numbered for characters, not inches.
- Find the printing point indicator, the marker that shows where the next character will land. The scale reading and the printing point may not line up exactly, so test before you rely on the numbers.
- Remember your machine’s pitch. A pica machine prints 10 characters per inch and an elite machine prints 12, so the same line length contains a different number of characters. See Pica vs Elite Type.
Setting the left margin
- Move the carriage to the position where you want the left edge of your text to start.
- Move the left margin stop to that position and release it so it locks in place.
- Use the carriage return lever to return to the left margin. See What the Carriage Return Lever Does and How to Use It.
- Type a few characters and check on the paper that the margin looks right.
Setting the right margin and the bell
- Move the carriage to the position where you want the line to end.
- Move the right margin stop to that point.
- Type a line and listen for the bell. It usually rings several characters before the stop, which gives you time to finish a word or hyphenate.
- Adjust the stop if the line ends too early or too late.
A common choice is margins of roughly an inch on each side for letters, but this is a matter of taste. Print a test page and adjust.
Using the margin release
The margin release key lets you type past a stop temporarily. Use it to finish a word that would not fit, to type a heading in the margin, or to start a line to the left of the usual margin. It does not move the stops, so the margins come back into effect on the next line.
Troubleshooting margins that will not hold
- The stop slides when you push it. The stop may not be locked. Check whether your model needs the stop to be released, repositioned and locked again. If it still slides, dirt or a worn locking part may be the cause.
- The carriage stops in the wrong place. The scale and printing point may not agree. Test and adjust using actual typing.
- The carriage slams the stop. It may be returning too fast. A worn or dirty carriage mechanism can contribute. See Typewriter Tab Stops Explained as tab and margin stops can interact.
- The bell does not ring. The bell mechanism may be dislodged or the stop may not be engaging it. A repairer can often fix this quickly.
- The keys lock up before the margin. Make sure the right margin stop is not set too close, and check that the carriage can move freely.
If the stops have loose or damaged parts, avoid forcing them.