What to know before you shop
Ribbons are the supply most likely to cause trouble, because machines differ and the wrong choice may not fit. Before buying, find your machine’s brand and model (often stamped on the body or on a plate near the carriage), check whether it uses open spools or a cartridge, and measure or look up the ribbon width. Our guide on loading and replacing a typewriter ribbon shows how to tell these apart.
Where to buy ribbons
- Specialist typewriter shops and repair dealers. Shops that service typewriters often sell ribbons and can tell you what fits a given model. Many sell online, and some are happy to answer questions by email.
- Online marketplaces such as eBay, Etsy and Amazon. These carry a wide range of ribbons, both new and old stock. Read the listing carefully for spool type, width and compatibility, and look at seller feedback.
- Office supply stores. Availability depends on the shop and country. Some stock universal spool ribbons or cartridges for certain electric models, though many do not.
- Typewriter forums and communities. Enthusiast groups can point you to reliable suppliers in your country, and sometimes members sell or swap supplies.
Prices and stock change often, so compare a few sellers. Avoid ribbons advertised only as “fits all typewriters,” because a universal ribbon still needs to match your machine’s spool size and width.
Buying paper
Most typewriters work well with ordinary office paper. Some points to consider:
- Weight. Plain bond or copy paper is fine for most uses. Very thin paper can tear under heavy keystrokes, and very thick card can be hard to feed.
- Size. Use the size that fits your carriage, usually letter or A4 in the corresponding region.
- Finish. A smooth, non-coated surface works best. Glossy or heavily coated paper may smudge.
- Cotton or “typewriter bond” paper. Some shops sell paper marketed for typewriters. It is optional but can feel nice to type on.
- Carbon paper and onionskin. Useful for copies, though carbon paper can be messy and its supply is limited.
A stack from the local office supplier is enough to begin with.
Correction supplies
- Correction fluid or “white-out.” Dab on, let dry fully, then retype. Do it carefully, because a wet patch can stick the paper to the platen or smear the ribbon.
- Correction tape. Self-adhesive strips you place over a mistake, which you can type over.
- Correction paper strips. Thin coated strips that you slide behind the typebar and retype the wrong character to cover it with white powder. They are traditional for manual typewriters.
- Typewriter erasers. A hard abrasive eraser, often with a small brush, can remove a typed character from plain paper. Use light pressure to avoid thinning the paper.
- Lift-off or cover-up ribbons. Some electric and electronic models have built-in correction ribbons that work with the machine’s correction key. These are model-specific.
Checklist before you order
- Brand and model of your typewriter.
- Open spools or cartridge? If spools, check the spool diameter and the type of spool hub.
- Ribbon width and material (fabric or film).
- Colour (black, black and red or other).
- Is the ribbon new stock? Older ribbons can be dry.
- Can you return it if it does not fit?
Tips for older or unusual machines
If your machine is rare or uses an unusual spool, you can sometimes re-spool a standard ribbon onto your own spool, as explained in the ribbon guide. Enthusiast communities often have tips for specific models. And if you are still choosing a machine, think about how easy supplies are to find as part of your decision. Common brands are generally easier to supply. See types of typewriters from old to new for a quick overview, or using a typewriter today for the wider picture.